Filtering one measure on two criterias based on two dimension members in one point map (SSAS)

[Anonymous]

Hi,

Is it possible to filter a measure based on two criterias that differ depending on two dimension membes in one point map when being connected to a SSAS model?

Scenario in more detail:

So, I have a measure displaying an average temperature on water flowing. Then I have two dimension members representing the water flowing in one direction from a given address and water flowing in the other direction from the same address. However, I only want to see the addresses where the temperature is x going in one direction and y going in the other direction. And I want the bubbles to size accordingly.

Location: Addresses

Legend: Water one direction, water the other direction

Size: Avg temperature measure

I hope it makes sense.

Thank you in advance!

[v-stephen-msft]

Hi @Anonymous ,

Sorry to disturb you...

But did I answer your question ? Please mark my reply as solution. Thank you very much.

[v-stephen-msft · Accepted solution]

Hi @Anonymous ,

You cannot add measures with a live SSAS connection. You can read more about it here: https://powerbi.microsoft.com/en-us/documentation/powerbi-desktop-analysis-services-tabular-data/ 

It's not supported to create measure when opening live connection to SSAS. You have to create those measures within your tabular model.

Best Regards,

Stephen Tao

If this post helps, then please consider Accept it as the solution to help the other members find it more quickly.