Dynamic slicer values based on visual selection

[Balaraju]

Hi All,

Is it possible to filter the slicer menus dynamically when a particular bar from a bar chart is selected?

Normally, when we select a slicer value, visuals get filtered. Can it be vice versa? If i select a visual(selecting a particular category in bar chart), will the slicer value gets filtered down?

[khyatipatel22]

I am looking for the solution for the same problem? any luck?

[v-yalanwu-msft]

Hi, @Balaraju ;

Unfortunately, the filtering of visual objects does not affect the slicer's filtering,
Visual objects can influence each other. For example, visual 1 is selected, and visual 2 will also change according to the filtering of visual 1, while slicer remains unchanged.

Best Regards,
Community Support Team_ Yalan Wu
If this post helps, then please consider Accept it as the solution to help the other members find it more quickly.

[amitchandak]

@Balaraju , Use a measure from bar visual in the visual level filter of the slicer and check it is not blank

[Raaaay]

Hi @amitchandak  Could you please share an example for that?