How do you change the size of the doughnut hole in doughnut charts?

[Mwaser]

I've seen a powerpoint that claims it is possible (http://www.arbelatech.com/userfiles/filemanager/04bc11qdw2sh2e3pvquk page 16) but don't see how to do it . . . .

[MFelix · Accepted solution]

Hi @Mwaser,

I don't know were the authors of this powerpoint went to get this information but in PBI is not possible to increase/decrease the size of the doughnut hole, this is possible in Excel but not in PBI.

Regards,

MFelix

[WillBeeSEA]

Perhaps not before, but presently, if you go to the formatting paint brush, select Slices then expand the Spacing selection, you can change the size of the hole by decreasing the inner radius percent:

[MFelix]

Hi @WillBeeSEA ,

This answer was back in 2017, at the time the visualizations customization was much lower then currently, now you can do this.

But thank you for adding this to the post so it can help others.

[WillBeeSEA]

Yes; exactly.  I was just completing the thread so if anyone looked for how to do this and found this question, they would also have the answer.  It might be better if archaic questions like this were archived or deleted, but they don't do that in the Forum.