Earn the coveted Fabric Analytics Engineer certification. 100% off your exam for a limited time only!
Hi All,
I want to refresh all the data from the database. When Increment Refresh enabled at the first time it will load all the data.
But later it will load only incremental basis.
Now I want to load once again all the Data from the database without affecting Incremental refresh. Is it possible??
Thanks
Amith D
Solved! Go to Solution.
Hi @Anonymous ,
Check below pictures. Turn off the Incremental Refresh then click 'refresh now'. After the refresh was complete, turn on the button again.
Best Regards,
Jay
Dear Jay, Community Support!
Just to be sure that I understand this solution right. So the suggested flow here is:
I am asking because I didn't find any option to do these in the service itself.
If it is the case then I would rather say it is not an acceptable solution rather a pretty dirty workaround 🙂
Hi @Anonymous ,
Check below pictures. Turn off the Incremental Refresh then click 'refresh now'. After the refresh was complete, turn on the button again.
Best Regards,
Jay
Hi @Anonymous ,
Just go into the Service, disable the incremental refresh. Manually refresh the whole thing. Then, after the refresh is done, turn back on the incremental refresh.
I would appreciate Kudos if my response was helpful. I would also appreciate it if you would Mark this As a Solution if it solved the problem. Thanks!
Proud to be a Datanaut!
Private message me for consulting or training needs.
Hi,
Thanks for the reply.
Can you show me how to do that. Because I dint found the option to do.
User | Count |
---|---|
64 | |
27 | |
25 | |
17 | |
11 |