Earn the coveted Fabric Analytics Engineer certification. 100% off your exam for a limited time only!
I made a powerbi report that I published to the service with success.
To schedule refresh on Power BI service, I use OAuth2. When I enter my credentials, I get two errors:
1. You need to use SSL (HTTPS) when you use OAuth 2.0 authentication.
2. Message: AADSTS90015: Requested query string is too long.
Everything works great on Power BI Desktop.
Solved! Go to Solution.
Hi @samira,
Did you notice that I used a Kusto connector while you used a Web connector? Please try again with the Kusto connector. Please refer to the snapshot below.
Best Regards,
Dale
I was coming across the message “You need to use SSL (HTTPS) when you use OAuth 2.0 authentication”. I resolved the issue by following these steps:
I found this helpful checklist here: link.
Hi @samira,
Could you please mark the proper answers as solutions?
Best Regards,
Dale
Hi @samira,
I set it up and refreshed successfully. I would suggest you make changes to your data source as the error message guided. The connection string could be like this: https://kkkkkkk.kusto.kkkkkk.net:443. The point is 443, which means the connection is encrypted.
Best Regards,
Dale
what type of changes should I make? I don't really understand your recommendation.
this is my connection string : https://kkkkkkk.kusto.kkkkkk.net:443/v1/rest/query?db/kkkkkkkkkkk&csl=.show version.
This is the error I get when i try to edit credentials.
Hi @samira,
Did you notice that I used a Kusto connector while you used a Web connector? Please try again with the Kusto connector. Please refer to the snapshot below.
Best Regards,
Dale