cancel
Showing results for 
Search instead for 
Did you mean: 

Column Width in Matrix Resizes Even When Auto Size turned OFF

 

 

I have a matrix within a report and have adjusted the columns width the way that I want them. 

 

photo 1.PNG

 

 

 

 

 

 

 

 

Auto Size is off, word-wrap is on:

photo 2.PNG

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

When I move to another tab in the report and then move back to the matrix, the columns are auto-sized.  This is driving me nuts.  I searched the forums, and it seems there was an issue fixed back in October, but it is not working.  Any help would be appreciated!  Thanks.

 

photo 3.PNG

 

 

 

 

Status: Needs Info
Comments
Helper I

I have a matrix within a report and have adjusted the columns width the way that I want them. 

 

photo 1.PNG

 

 

 

 

 

 

 

 

 

Auto Size is off, word-wrap is on:

 

photo 2.PNG

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

When I move to another tab in the report and then move back to the matrix, the columns are auto-sized.  This is driving me nuts.  I searched the forums, and it seems there was an issue fixed back in October, but it is not working.  Any help would be appreciated!  Thanks.

 

photo 3.PNG

 

Microsoft

@ConnieMaldonado

 

Could you please try the workaround below to see if it works?

Recreate a new Matrix with the same fields, but dragging them in the order preferred (dont reorder after creation).

 

If issue persists with above workaround, please try above steps until 11/19/2017. A related fix will be deployed at that time.

 

Best Regards,
Herbert

Impactful Individual
Status changed to: Needs Info
 
New Member

I have experience this same issue with the total column in a matrix.  All other columns seem to remain fixed as intended; however, when a new slicer value is selected and the dependent matrix refreshes the grand total column on the matrix usually gets crunched down so that the height of the entire matrix exceeds the alotted space (since row heights get doubled).  It's quite annoying because you have manually adjust the total column each time you want to look at new data.