cancel
Showing results for 
Search instead for 
Did you mean: 
Reply
Gordon2 Member
Member

capture slicer selection

Need a dax to capture second higher slicer selection. In my case it is 100:

 

Capture4.PNG

I know I can get selected value when single selection with:

SELECTEDVALUE('price table'[price max])

 

But how to get this with multiple ones?

I am gonna use it later to create sales measure to work on ranges selected on slicer

1 ACCEPTED SOLUTION

Accepted Solutions
Community Support Team
Community Support Team

Re: capture slicer selection

@Gordon2,

 

Change it as follows.

Measure =
MAXX (
    FILTER (
        ALLSELECTED ( 'price table'[price max] ),
        'price table'[price max] < MAX ( 'price table'[price max] )
    ),
    'price table'[price max]
)
    + 0
Community Support Team _ Sam Zha
If this post helps, then please consider Accept it as the solution to help the other members find it more quickly.
4 REPLIES 4
Community Support Team
Community Support Team

Re: capture slicer selection

@Gordon2,

 

You may use measure below.

Measure =
MINX (
    TOPN ( 2, VALUES ( 'price table'[price max] ), 'price table'[price max], DESC ),
    'price table'[price max]
)
Community Support Team _ Sam Zha
If this post helps, then please consider Accept it as the solution to help the other members find it more quickly.
Gordon2 Member
Member

Re: capture slicer selection

Thanks Sam,

 

I think I was not precise in my question. Your measure is working but not in all cases, which I had not mentioned before.

It works on total only.

Sorry for this. I hope you can help further.

How to do a measure to work in a matrix like this?:

 

Capture5.PNG

An output should show the figures like those on red.

 

Community Support Team
Community Support Team

Re: capture slicer selection

@Gordon2,

 

Change it as follows.

Measure =
MAXX (
    FILTER (
        ALLSELECTED ( 'price table'[price max] ),
        'price table'[price max] < MAX ( 'price table'[price max] )
    ),
    'price table'[price max]
)
    + 0
Community Support Team _ Sam Zha
If this post helps, then please consider Accept it as the solution to help the other members find it more quickly.
Highlighted
Gordon2 Member
Member

Re: capture slicer selection

Perfect, Thanks!