Reply
Member
Posts: 59
Registered: ‎06-17-2018
Accepted Solution

capture slicer selection

Need a dax to capture second higher slicer selection. In my case it is 100:

 

Capture4.PNG

I know I can get selected value when single selection with:

SELECTEDVALUE('price table'[price max])

 

But how to get this with multiple ones?

I am gonna use it later to create sales measure to work on ranges selected on slicer


Accepted Solutions
Community Support Team
Posts: 4,016
Registered: ‎07-09-2016

Re: capture slicer selection

@Gordon2,

 

Change it as follows.

Measure =
MAXX (
    FILTER (
        ALLSELECTED ( 'price table'[price max] ),
        'price table'[price max] < MAX ( 'price table'[price max] )
    ),
    'price table'[price max]
)
    + 0
Community Support Team _ Sam Zha
If this post helps, then please consider Accept it as the solution to help the other members find it more quickly.

View solution in original post


All Replies
Highlighted
Community Support Team
Posts: 4,016
Registered: ‎07-09-2016

Re: capture slicer selection

@Gordon2,

 

You may use measure below.

Measure =
MINX (
    TOPN ( 2, VALUES ( 'price table'[price max] ), 'price table'[price max], DESC ),
    'price table'[price max]
)
Community Support Team _ Sam Zha
If this post helps, then please consider Accept it as the solution to help the other members find it more quickly.
Member
Posts: 59
Registered: ‎06-17-2018

Re: capture slicer selection

[ Edited ]

Thanks Sam,

 

I think I was not precise in my question. Your measure is working but not in all cases, which I had not mentioned before.

It works on total only.

Sorry for this. I hope you can help further.

How to do a measure to work in a matrix like this?:

 

Capture5.PNG

An output should show the figures like those on red.

 

Community Support Team
Posts: 4,016
Registered: ‎07-09-2016

Re: capture slicer selection

@Gordon2,

 

Change it as follows.

Measure =
MAXX (
    FILTER (
        ALLSELECTED ( 'price table'[price max] ),
        'price table'[price max] < MAX ( 'price table'[price max] )
    ),
    'price table'[price max]
)
    + 0
Community Support Team _ Sam Zha
If this post helps, then please consider Accept it as the solution to help the other members find it more quickly.
Member
Posts: 59
Registered: ‎06-17-2018

Re: capture slicer selection

Perfect, Thanks!