cancel
Showing results for
Did you mean:
Highlighted
Anonymous
Not applicable

## Row context measure

Hello everyone,

Need some help.

I have Project KPI board. Everything was fine till that point, where I had to calculate how much Bad projects are?

I think it's because Status measure I calculated is not row based.

`Status = IF([CPI]>0,7; "Good";IF([CPI]>0,5; "Need attention";"Bad"))`
`CPI = [EV]/[Worklog]`
Spoiler
`EV = CALCULATE(  SUM(jira[Billabe Hours]); FILTER(jira;jira[Resolution]<>BLANK()))`
`Worklog = SUM(Worklog[WorklogHours])`

I looked through some posts, but I couldn't get right DAX to fit.

Can anyone help me, this is pbix file:

1 ACCEPTED SOLUTION

Accepted Solutions
Community Support Team

## Re: Row context measure

HI @Anonymous ,

Based on my understand, In your scenario, the CPI of Project 2 and 3 are less than 0.5, then the result will be 2.

You can use the following DAX query:

```Measure =
VAR a =
ADDCOLUMNS ( VALUES ( Component[Project] ), "CPIa", [CPI] )
RETURN
COUNTROWS ( FILTER ( a, [CPIa] < 0.5 && Component[Project] <> BLANK () ) )```

The measure you shared will not get the true data, the [CPI] is a measure, it will be calculated based on the filter, but in the measure "BAD Project", it will not have the context of Project names.

Best Regards,

Teige

4 REPLIES 4
Community Support Team

## Re: Row context measure

Hi @Anonymous ,

Based on my check, I haven't found problem in your DAX query, could you please tell me what's problem did you meet?

Best Regards,

Teige

Anonymous
Not applicable

## Re: Row context measure

Thanks, @TeigeGao for the replay

Problem is by calculating the number of BAD projects.

The measure

`BAD Project = CALCULATE(DISTINCTCOUNT(Component[Project]);FILTER(Component;[CPI]<0,5))`
Doesn't work it brings all projects
Community Support Team

## Re: Row context measure

HI @Anonymous ,

Based on my understand, In your scenario, the CPI of Project 2 and 3 are less than 0.5, then the result will be 2.

You can use the following DAX query:

```Measure =
VAR a =
ADDCOLUMNS ( VALUES ( Component[Project] ), "CPIa", [CPI] )
RETURN
COUNTROWS ( FILTER ( a, [CPIa] < 0.5 && Component[Project] <> BLANK () ) )```

The measure you shared will not get the true data, the [CPI] is a measure, it will be calculated based on the filter, but in the measure "BAD Project", it will not have the context of Project names.

Best Regards,

Teige

Anonymous
Not applicable

## Re: Row context measure

Thanks, @TeigeGao it worked!

Announcements