Showing results for 
Search instead for 
Did you mean: 
Resolver I
Resolver I

Need Help | Filter Map by 'Top N' where ranking is done using a measure

We have a dynamic slicer (Top 5/10/25/ALL).

Using this slicer we are calculating the following table.(please refer the TABLE image below)

In this table we are dynamically ranking the 'Sellers' by the volume

[DynamicRankMeasure] = IF(RANKX(ALLSELECTED(tblImportMaster[Shipper]),[ SelectedMeasure],,DESC)<=[ SelectedTopNValue],[ SelectedMeasure],BLANK()) 

So if we select top 5, then the table would show the top 5 sellers by volume (and their respective data). Now there is a column called 'SellerCountryCount' which basically gives us the distinct count of 'countries' where the seller is located.

Now, I need to plot these two distinct countries on the map.


If I select top 5 sellers, I get the this data. But if you notice I just have two distinct countries in the table. So I need to plot these 'two countries' only.

Currently the map shows all the countries in my data when I put 'Country' on the location and 'Volume' (based on the rank) on the color saturation

Can we achieve this using DAX in Power BI ? Any help here would be appreciated. Thank you.

Community Support
Community Support

Hi ketan10,


Does "Country" column have relationship between table 'tblImportMaster'? You should build a relationship between Country column and 'tblImportMaster'[seller] column and try again.



Jimmy Tao


Helpful resources



We are excited to announce the Power BI Super Users!

Wave Release 2

Check out the updates in Power BI.

Overview of Power BI 2020 release wave 2!

Get Ready for Power BI Dev Camp

Get Ready for Power BI Dev Camp

Mark your calendars and join us for our next Power BI Dev Camp!.


The largest Power BI virtual conference

100+ sessions, 100+ speakers, Product managers, MVPs, and experts. All about Power BI. Attend online or watch the recordings.

Top Solution Authors
Top Kudoed Authors