How to filter the correct value of Denominator to get the Percentage Progress

[AbegaelFollero]

Attached is my not-yet finished report for Pipeline monitoring Progress.

I have prepared 2 slicers for LIne Id modelled in S3d and Line No as per line list.

Now, for my percentage, it is ration of

NUMERATOR = DISTINCTCOUNT(S3D_STATUS_REPORT[Line ID Modelled in S3D])

And for denominator,

DENOMINATOR = COUNTX(FILTER(

LINE_LIST_DATA,

LINE_LIST_DATA[Unit No.] IN {"01","02","03","04","09","32","33","34","43","45","46","48","60","61","62","70"}), LINE_LIST_DATA[Unit No.] )

So I got the Percentage progress = 61.70 %

Now, that I have filtered the Unit 01, I have encountered problem.

My Percentage Progress resulted based on the Numerator and my denominator was still based on the total Line number in S3D.

Please help me to how to filter the correct Count of Line Number in List per unit No.

[V-lianl-msft]

Hi @AbegaelFollero ,

Try to modify DENOMINATOR  as below:

DENOMINATOR = COUNTROWS(FILTER(
LINE_LIST_DATA,
LINE_LIST_DATA[Unit No.] IN {"01","02","03","04","09","32","33","34","43","45","46","48","60","61","62","70"}))

If the problem persists,could you share the sample pbix with dummy data?

https://community.powerbi.com/t5/Community-Blog/How-to-provide-sample-data-in-the-Power-BI-Forum/ba-... 

Best Regards,
Liang
If this post helps, then please consider Accept it as the solution to help the other members find it more quickly.

[amitchandak]

@AbegaelFollero ,Can you share sample data and sample output in table format? Or a sample pbix after removing sensitive data.