cancel
Showing results for 
Search instead for 
Did you mean: 
Reply
shivani1 Frequent Visitor
Frequent Visitor

Enable/disable load in Reference and Duplicate

Hello everyone,

 

I am a little confused with the difference between Reference and Duplicate.

 

Lets take an example here,

If I have a table say A which is connected to a datasource say SharePoint and a table B which is a reference of table A.

If I disable load of table A and refresh table B, it gets refreshed, so it means that table B can exist independently.

My concern here is, what is the point of having duplicate then?

1 ACCEPTED SOLUTION

Accepted Solutions
Community Support Team
Community Support Team

Re: Enable/disable load in Reference and Duplicate

Hi @shivani1 

 

You may check this thread for reference. Here is the document about Reference vs Duplicate.

 

Regards,

Cherie

Community Support Team _ Cherie Chen
If this post helps, then please consider Accept it as the solution to help the other members find it more quickly.
2 REPLIES 2
Highlighted
Super User
Super User

Re: Enable/disable load in Reference and Duplicate

Duplicate duplicates all of your M code, providing you a starting point to make changes whereas Reference creates a reference to the original query.


Did I answer your question? Mark my post as a solution!

Proud to be a Datanaut!


Community Support Team
Community Support Team

Re: Enable/disable load in Reference and Duplicate

Hi @shivani1 

 

You may check this thread for reference. Here is the document about Reference vs Duplicate.

 

Regards,

Cherie

Community Support Team _ Cherie Chen
If this post helps, then please consider Accept it as the solution to help the other members find it more quickly.