Data lines with 0 values displayed anomalies when selected using a slicer

[DTKH]

I am using the line chart to display a trend of defects by dept. Some depts has 0 defects but still required to be displayed in the chart.

To do this, I added each dept defects count into the Y-axis.

However, when selected a dept that has 0 value, 2 anomalies occurred:

1. Instead of displaying the selected dept, it shows the first dept. The correct dept is shown is selected a dept with values.

2. The 0 on the line appeared more then 1 as shown in the picture.

Are there alternate settings to resolve the above issues?

Thank you in advance!

 

[sturlaws]

Hi, @DTKH,

have you created a measure, or are you using an implicit measure? Do you have a date-table?

I am not able to recreate your issue, but you could try to write a measure like this:

Measure = SUMX('Table',if(ISBLANK('Table'[value]),0,'Table'[value])) 

Cheers,
Sturla

If this post helps, then please consider Accepting it as the solution. Kudos are nice too.

[DTKH]

Hi @sturlaws ,

I am getting the data from a table like the following:

The following columns are selected for the Y-axis:

Cheers!

[sturlaws]

How have you created your slicer?

Anyway, the your table is not optimal for what you are trying to do. I would place department on rows instead, like this:

[DTKH]

Hi @sturlaws ,

I use the "Dept" as the field for the slicer.

Sorry, I missed showing that in the table screenshot.