ArcGIS Maximum 1500 addresses were located

[Anonymous]

I have a heatmap with over 1500 points, which shows the erro "Maximum 1500 addresses were located"

When I use a slicer and reduce the points to under 1500 the error remains.

Does the map recalulate the extra points the were not shown in the original map when a slicer is used? Even through the error message stays there?

[Eric_Zhang]

---

@Anonymous wrote:

I have a heatmap with over 1500 points, which shows the erro "Maximum 1500 addresses were located"

When I use a slicer and reduce the points to under 1500 the error remains.

Does the map recalulate the extra points the were not shown in the original map when a slicer is used? Even through the error message stays there?

---

@Anonymous

I don't exceed the maximum even though with more than 5000 addresses. So could you be more specific on how to reproduce that issue? As the the slicer, I think the map shall do the recaculation, could you test with less points?

By the way, since the ArcGIS is produced by ESRI, for better response, I'd suggest asking support from ESRI.